Toshiba Tosvert VF-A5 - Manual (Page 46)

7.4 Operation Mode Selection
The methods for operation and adjustment from the operation panei, validating/invalidating operating
commands from the terminal block, selection of the stopping method, and resetting are explained in this
section.
7.4.1 Operation Mode Changeover
Panel operation mode or terminal block operation mode can be selected.
• When terminal block operation mode (REMOTE) is selected, commands from the panel are ignored.
• When panel operation mode (PANEL) is selected, commands from the terminal block are ignored.
The operation mode is changed by the PANEL/REMOTE key, and can be done only when the motor is
stopped. (When stopped, OFF or a frequency display of D.0 will be shown.)
Terminal operation mode is automatically entered after power is turned on, unless the input mode is preset
as explained below. The panel control LED will be lit when panel operation is selected.
7.4.2 Run/stop Command [ j C n O d I in C i - . u t ]
The following sources can be selected for run/stop commands (command mode).
C n o d setting Function
0 Only RS232C input valid
1 Terminal block input valid Note)
2 Panel input valid
a
Communication option board input
valid
H All valid
Note) The intended input functions are
G r. 5 fc ; input (fc * in
terminal function setting values 0 to 5,
8 and 9, on page 55.
(Refer to pages 55 and 86 for details.)
7.4.3 Frequency Command Source Setting Function [ I F f l D d 1 in D r . u t ]
This function allows the selection of the frequency command source as follows, according to the frequency
setting mode selection parameter (I F i l D d l in 0
r . u t
).
F n o d setting Function
0 Only RS232C input valid
1 Terminal block input valid
S Panel input valid
3 Communication option board input
valid
H All valid
-40