Toshiba Tosvert VF-A5 - Manual (Page 66)

LJ r .
5
(Terminal Selection Parameters)
I b F I b 5 F
u h 0 d 0 b 0 h
Input/output terminai response time
selections
Related parameters
I b F
I b S F
I b l F
D b O d D b 3 d
O b O h ~ D b 3 h
Input terminals (R, S1, S2, S3, S4, S5, S6, S7) response time selection
input terminals (F, RES, ST) response time selections
Output terminals (RCH, LOW, Fl_ OUT) delay times
Output terminals (RCH, LOW, FL, OUT) hold times
If noise effects or input contact point chattering results in undesirable or incorrect operation, increase the
terminal response time selections. As the setting value is increased, the response time v\/ill also increase
proportionally.
* When set to / , the response time will be the shortest, and when set to / Q D . the response time will be the
max. (approx. 200mS).
* The output terminals can be set separately for the delay time when turning ON, and the output hold time
when turning OFF.
When the acceleration/deceleration time is 0.1 sec. or less and an analog frequency input
is used, chattering may occur in the acceleration/deceleration complete signal or low
speed detection signal. Set the output terminal delay times (filter functions) O b O d
D b ¡ d O b E d O b 3 d 3s necessary
60 -