KEYENCE TM-3000 Series - Manual (Page 8)

1-4
Gett
ing
Started
- Setup software TM-H1 TM-Navigator User’s Manual -
Starting and Exiting TM-Navigator
Starting and Exiting TM-Navigator
This section describes how to start and exit TM-Navigator.
Reference
• Multiple instances of TM-Navigator cannot be started
up at the same time.
• The USB and Ethernet interfaces on a single controller
cannot be used at the same time.
• Communication is disabled when the controller is in the
"Program mode".
Start
TM-Navigator starts up in one of the following methods:
• Start up with the default values
• Read from a file
• Read the settings of the connected controller
1
Click the [Start] button and then select
TM-Navigator, or double-click on the
TM-Navigator icon on the desktop.
TM-Navigator starts up. The main screen and the
[Select the settings to display upon startup] dialog
box are displayed.
Reference
Click the [Exit] button to exit TM-Navigator.
2
Select the setting contents and press
the [OK] button.
„ Step 2-1 When [Start up with the default values] is
selected
Select [Start up with the default values] the first time that
TM-Navigator is started up or when creating a new
program.
Use the following procedure to start up.
1
Select [Start up with the default values]
and click the [OK] button.
TM-Navigator starts up with the default states for all
setting files.
The operation when [Start up with the default values] is
selected is determined based on whether the head data
has been saved on the hard disc drive of the computer or
not.
• If not registered (When using TM-Navigator for the first
time):
Select the head model to use from the pull-down menu
and start up.
• If registered:
The head data already recorded is used at start up. The
head model cannot be selected.
"Help:Ref.Value" (page 4-11)