KEYENCE TM-3000 Series - Manual (Page 32)

4-10
- Setup software TM-H1 TM-Navigator User’s Manual -
View Image
Displa
ying
the
Measurem
ent Data
Functions and Usage of Re-measure (Ref.Value)
This function measures images obtained from the controller or images saved with the image storage.
The measurement settings can be changed while confirming the measurement result (measurement value).
Use this function to analyze the cause for NG data and to optimize the measurement setting.
Re-measure (Ref.Value) screen
When [Re-measure (Ref.Value)] is clicked, reference values are displayed on the right side of the image display screen
(or image storage screen).
(1) [Re-measure (Ref.Value)]
This displays the measurement values in OUT1 to OUT16 according to the setting contents for (2).
The measurement results from the controller are displayed in green or red. Re-measure (Ref.Value) values are
displayed in white.
For details of Re-measure (Ref.Value), see page 4-11.
(2) "OUT meas" / "Element"
This sets "OUT meas" / "Element" for Re-measure (Ref. Value).
For setting procedures, see "How to Set Re-measure (Ref.Value)" (page 4-11).
(3) Load from setting
This loads the setting contents currently registered with TM-Navigator.
(4) Reflect to setting
This displays the setting contents in the setting for TM-Navigator.
To send the new settings to the controller, establish the communication status between TM-Navigator and the
controller, and click "Send settings to controller" (page 2-2).
(2)
(1)
(3)
(4)