KEYENCE TM-3000 Series - Manual (Page 12)

1-8
Gett
ing
Started
Connecting via USB
- Setup software TM-H1 TM-Navigator User’s Manual -
Installing the USB Driver
The driver is installed at the same time as the application
software for Windows 7, Vista, XP, and 2000. Normally
following operations are not necessary.
If the driver installation is cancelled while installing the
application software, follow the procedure below to
manually install the USB driver.
Installing on Windows XP
Connect the controller to a computer with Windows XP. If
the controller is being connected for the first time, the
USB driver for the TM-3000 Series must be installed. The
connection is automatically recognized after the USB
driver has been installed once and does not need to be
installed again.
This section explains how to install the driver for the TM-
3000 Series on a computer with Windows XP for the first
time.
Hardware detection must be performed when installing
the USB driver for the TM-3000 Series.
Use the following methods to install the driver.
1
Start up Windows XP and log in as a
user that has Administrator privileges
(or similar privileges that permit
changing system settings).
2
Connect the USB port on the computer
with the USB port on the TM-3000
Series controller using the USB cable.
The message "Found New Hardware" appears and
the Hardware Update Wizard starts up.
3
Select [Install from a list or specific
location (Advanced)], and click the
[Next] button.
4
Select [Search for the best driver in
these locations.] and check the box
next to [Include this location in the
search:].
Then, enter "C:\Program Files\KEYENCE\TM-
Navigator\driver" in the text box and click the [Next]
button.
Reference
"C:\Program Files\KEYENCE\TM-Navigator\driver"
represents the location where TM-Navigator will be
installed.
Change the location depending on the system
environment.
5
Continue installation according to the
on-screen instructions.
When installation of the USB driver ends
successfully, the [Completing the Hardware Update
Wizard] dialog appears.
6
Click the [Finish] button to complete
installation of the USB driver.
Reference
When installing onto a computer with Windows 2000,
install the USB driver according to the wizard.