KEYENCE TM-3000 Series User Manual
Page 45
4-23
Displa
ying
the
Measurem
ent Data
- Setup software TM-H1 TM-Navigator User’s Manual -
Image Storage
Starting image storage
1
Connect TM-Navigator and the
controller, check that communication
can be established, and then measure
the target.
"Connecting via USB" (page 1-7)
"Connecting via Ethernet" (page 1-9)
2
Set the storage settings to "Image
storage" in the common settings for
the controller.
"TM-3000 Series User's Manual"
3
Click the [Image storage] icon on the
tool bar.
The [Image storage] window appears.
4
Click the [Start image storage] button.
The controller starts storing the measurement values.
Reference
• The storage interval is determined based on the
storage settings. Data can be stored in succession or at
a specified timing. To stop the data storage before the
buffer is full, click the [Stop storage] button.
When you click the [Start image storage] button again
after the storage is stopped once, the storage is
resumed from the point where the storage was stopped.
• If communication is not possible between TM-Navigator
and the controller, or if a head is not connected, the
following dialog appears shortly after clicking the [Start
image storage] button or the [Read storage data]
button.
Check the connection between each head and
between TM-Navigator and the controller. Check that
the controller is set to [Image storage].
Loading the storage data
Displays the data stored in the controller on TM-
Navigator.
1
Connect TM-Navigator and the
controller, check that communication
can be established, and then measure
the target.
"Connecting via USB" (page 1-7)
"Connecting via Ethernet" (page 1-9)
2
Start or stop data storage according to
"Starting image storage" (page 4-23).
3
Click the [Read storage data] button.
The storage data is displayed on TM-Navigator.