Cub Cadet ISeries User Manual

Page 91

STEERING-IVT

Remove the two screws in the cargo net area, at
the bottom of the dash. See Figure 6B.13.

NOTE: The cargo net was removed for a clearer
picture. Do not remove the net to remove the
screws.

Remove the screws at the bottom of the dash,
on each side. See Figure 6B.14.

NOTE: Do not disconnect the wiring. Leave the
dash lose so that it can be lifted to remove the
fender.

Remove fender by following the steps described
in Chapter 4: Body/Chassis.

Figure 6B.13

Remove these screws

Figure 6B.14

Screw removed

Lock Steering Gear Box in Neutral Position:

7a. Remove the 1/4”-20 plug screw from the

steering gear box centering port using a 3/8”
wrench. See Figure 6B.15.

7b. Using a 1/4”-20x2” bolt, thread it into the

steering box centering port until you feel it
touch the steering rack. While trying to gen-
tly thread the bolt further, slowly rotate the
steering shaft back and forth until the bolt
seats into the detent in the steering rack.
Finger tighten the screw to set the screw
fully into the detent. The steering gear box is
now centered and locked.
See Figure 6B.16.

Figure 6B.15

2” screw

Figure 6B.16

2” bolt