Cub Cadet ISeries - Manual (Page 26)

BODY/CHASSIS
20
2e. Remove the screws at the bottom of the
dash, on each side. See Figure 4.13.
2f. The dash can now by lifted over the steering
shaft and placed to the side or on top of the
engine.
NOTE: If the throttle and choke cable are still
attached to the dash, care should be taken to
prevent damage to them when lifting the dash.
3. Install the dash by following the above steps in
reverse order.
Remove the fender
1. Remove the dash by following the steps
described in the previous section of this chapter.
2. Disconnect the wires to the seat switch.
NOTE: Tractors built prior to 2008 have two yel-
low wires that go to a switch on the side of the
seat bracket. See Figure 4.14.
NOTE: Tractor built from 2008 to present have
two yellow wires and a green wire that go to a
switch inside the seat.
NOTE: When reconnecting the wires, the posi-
tion of the two yellow wires does not affect the
operation of the tractor.
3. Remove the seat bracket and seat as one piece.
4. Remove the grip from the deck lift handle.
Figure 4.13
Screw removed
Figure 4.14
Seat switch wires
Remove the nut
and bolt to remove
seat
Figure 4.15
Seat switch
Seat bracket
mounting screws