Pilz PNOZ s30 24-240VACDC 2 n/o 2 n/c - Manual (Page 4)

Content
Operating Manual PNOZ s30
1001715-EN-13
4
6.1.5.2 Connect rotary encoder with Z index to speed monitor 33
6.1.5.3 Connect rotary encoder to the speed monitor via an adapter 33
6.1.6 Connection of proximity switch and rotary encoder 34
6.1.7 Reset circuit 35
6.1.8 Feedback circuit 36
6.1.9 Select inputs 36
6.1.10 Semiconductor outputs 36
6.1.11 EMC-compliant wiring 36
6.2 Display menu - Configuration 38
6.2.1 Create configuration overview 39
6.2.2 Operate rotary knob 39
6.2.3 Configure Speed Monitor 40
6.2.4 Password protection 40
6.2.5 Use chip card 41
6.2.5.1 Insert chip card 42
6.2.5.2 Write data to chip card 42
6.2.5.3 Read data from chip card 43
6.2.5.4 Transfer device parameters 43
6.2.5.5 Duplicate chip card 43
6.2.6 Menu overview 44
6.2.6.1 Permanent display 44
6.2.6.2 Basic settings Ini pnp pnp 44
6.2.6.3 Basic settings for the rotary encoder 45
6.2.6.4 Settings 47
6.2.6.5 Advanced settings 53
6.2.6.6 Information 55
6.2.7 Example: Configure basic configuration 2 58
Section 7 Operation 59
7.1 Display elements for device diagnostics 59
7.1.1 LEDs 59
7.1.2 Display 60
7.1.2.1 Error stack entries 60
7.1.2.2 Current error messages 60
7.1.2.3 Open circuit message 66
7.1.2.4 Frequency difference message on proximity switch 66
Section 8 Technical details 67
8.1 Safety characteristic data 71
Section 9 Supplementary data 72
9.1 Service life graph of output relays 72
9.2 Categories 72
9.2.1 Safety level 72
9.2.2 Safety functions 73
9.2.3 Safety-related characteristic data for operation with non-safety-related ro-
tary encoder without additional requirements 74