Kontron AT8904 CLI - Manual (Page 77)

AT8904M Switching Commands
Page 2 - 41 AT8904M CLI Reference Manual
2.10.11.1 no dot1x re-authentication
This command disables re-authentication of the supplicant for the specified port.
Format
no dot1x re-authentication
Mode Interface Config
2.10.12 dot1x system-auth-control
Use this command to enable the dot1x authentication support on the switch. While
disabled, the dot1x configuration is retained and can be changed, but is not activated.
Default disabled
Format
dot1x system-auth-control
Mode Global Config
2.10.12.1 no dot1x system-auth-control
This command is used to disable the dot1x authentication support on the switch.
Format.
no dot1x system-auth-control
Mode Global Config
2.10.13 dot1x timeout
This command sets the value, in seconds, of the timer used by the authenticator state
machine on this port. Depending on the token used and the value (in seconds) passed,
various timeout configurable parameters are set. The following tokens are supported.
reauth-period: Sets the value, in seconds, of the timer used by the authenticator state
machine on this port to determine when re-authentication of the supplicant takes place.
The reauth-period must be a value in the range 1 - 65535.
quiet-period: Sets the value, in seconds, of the timer used by the authenticator state
machine on this port to define periods of time in which it will not attempt to acquire a
supplicant. The quiet-period must be a value in the range 0 - 65535.
tx-period: Sets the value, in seconds, of the timer used by the authenticator state
machine on this port to determine when to send an EAPOL EAP Request/Identity
frame to the supplicant. The quiet-period must be a value in the range 1 - 65535.
supp-timeout: Sets the value, in seconds, of the timer used by the authenticator state
machine on this port to timeout the supplicant. The supp-timeout must be a value in the
range 1 - 65535.
server-timeout: Sets the value, in seconds, of the timer used by the authenticator state
machine on this port to timeout the authentication server. The supp-timeout must be a
value in the range 1 - 65535.
Default reauth-period: 3600 seconds
quiet-period: 60 seconds
tx-period: 30 seconds
supp-timeout: 30 seconds
server-timeout: 30 seconds