Kontron AT8904 CLI - Manual (Page 70)

Switching Commands AT8904M
AT8904M CLI Reference Manual Page 2 - 34
NOTE: If GVRP is disabled, the system does not forward GVRP messages.
2.8.1 set gvrp adminmode
This command enables GVRP on the system.
Default disabled
Format
set gvrp adminmode
Mode Privileged EXEC
2.8.1.1 no set gvrp adminmode
This command disables GVRP.
Format
no set gvrp adminmode
Mode Privileged EXEC
2.8.2 set gvrp interfacemode
This command enables GVRP on a single port (Interface Config mode) or all ports
(Global Config mode).
Default disabled
Format
set gvrp interfacemode
Modes Interface Config
Global Config
2.8.2.1 no set gvrp interfacemode
This command disables GVRP on a single port (Interface Config mode) or all ports
(Global Config mode). If GVRP is disabled, Join Time, Leave Time and Leave All
Time have no effect.
Format
no set gvrp interfacemode
Modes Interface Config
Global Config
2.8.3 show gvrp configuration
This command displays Generic Attributes Registration Protocol (GARP) information
for one or all interfaces.
Format
show gvrp configuration {<slot/port> | all}
Modes Privileged EXEC
User EXEC
Interface Valid slot and port number separated by forward slashes.
Join Timer Specifies the interval between the transmission of GARP PDUs regis-
tering (or re-registering) membership for an attribute. Current
attributes are a VLAN or multicast group. There is an instance of this
timer on a per-Port, per-GARP participant basis. Permissible values
are 10 to 100 centiseconds (0.1 to 1.0 seconds). The factory default is