Kontron AT8904 CLI - Manual (Page 251)

AT8904M Utility Commands
Page 5 - 51 AT8904M CLI Reference Manual
Type
Type determines whether or not the ICMP message is a
REQUEST or a RESPONSE.
5.11.9.1 no debug ping packet
This command disables tracing of ICMP echo requests and responses.
Format
no debug ping packet
Mode
Privileged EXEC
5.11.10 debug rip packet
This command turns on tracing of RIP requests and responses. This command takes no
options. The output is directed to the log file.
Default
disabled
Format
debug rip packet
Mode
Privileged EXEC
A sample output of the trace message is shown below.
<15> JAN 01 00:35:15 192.168.17.29-1 RIP[181783160]:
rip_map_debug.c(96) 775 %
Pkt RX on Intf: 1/0/1(1), Src_IP:43.1.1.1 Dest_IP:43.1.1.2
Rip_Version: RIPv2 Packet_Type:RIP_RESPONSE
ROUTE 1): Network: 10.1.1.0 Mask: 255.255.255.0 Metric: 1
ROUTE 2): Network: 40.1.0.0 Mask: 255.255.0.0 Metric: 1
ROUTE 3): Network: 10.50.50.0 Mask: 255.255.255.0 Metric: 1
ROUTE 4): Network: 41.1.0.0 Mask: 255.255.0.0 Metric: 1
ROUTE 5): Network:42.0.0.0 Mask:255.0.0.0 Metric:1
Another 6 routes present in packet not displayed.
The following parameters are displayed in the trace message:
TX/RX
TX refers to a packet transmitted by the device. RX refers
to packets received by the device.
Intf
The interface that the packet came in or went out on. For-
mat used is slot/port (internal interface number).
Src_IP
The source IP address in the IP header of the packet.
Dest_IP
The destination IP address in the IP header of the packet.
Rip_Version
RIP version used .
Packet_Type
Type of RIP packet. .
Routes
Up to 5 routes in the packet are displayed in the follow-
ing format:
Network: Mask Next_Hop Met-
ric
The next hop is only displayed if it is different from
0.0.0.0.
For RIPv1 packets, Mask is always 0.0.0.0.
Number of routes not printed
Only the first five routes present in the
packet are included in the trace. There is another notifi-
cation of the number of additional routes present in the
packet that were not included in the trace.