Kontron AT8904 CLI - Manual (Page 271)

AT8904M Management Commands
Page 6 - 17 AT8904M CLI Reference Manual
Otherwise, this value is ANDed with the mask to determine the range of allowed client
IP addresses. The name is the applicable community name.
Default 0.0.0.0
Format
snmp-server community ipaddr
Mode Global Config
6.6.3.1 no snmp-server community ipaddr
This command sets a client IP address for an SNMP community to 0.0.0.0. The name is
the applicable community name.
Format
no snmp-server community ipaddr
Mode Global Config
6.6.4 snmp-server community ipmask
This command sets a client IP mask for an SNMP community. The address is the
associated community SNMP packet sending address and is used along with the client
IP address value to denote a range of IP addresses from which SNMP clients may use
that community to access the device. A value of 255.255.255.255 will allow access
from only one station, and will use that machine's IP address for the client IP address.
A value of 0.0.0.0 will allow access from any IP address. The name is the applicable
community name.
Default 0.0.0.0
Format
snmp-server community ipmask
Mode Global Config
6.6.4.1 no snmp-server community ipmask
This command sets a client IP mask for an SNMP community to 0.0.0.0. The name is
the applicable community name. The community name may be up to 16 alphanumeric
characters.
Format
no snmp-server community ipmask
Mode Global Config
6.6.5 snmp-server community mode
This command activates an SNMP community. If a community is enabled, an SNMP
manager associated with this community manages the switch according to its access
right. If the community is disabled, no SNMP requests using this community are
accepted. In this case the SNMP manager associated with this community cannot
manage the switch until the Status is changed back to Enable.
Default private and public communities - enabled
other four - disabled
Format
snmp-server community mode
Mode Global Config