Kontron AT8904 CLI - Manual (Page 141)

AT8904M Routing Commands
Page 3 - 27 AT8904M CLI Reference Manual
3.7.10 area nssa translator-role (OSPF)
This command configures the translator role of the NSSA. A value of
always
causes
the router to assume the role of the translator the instant it becomes a border router and
a value of
candidate
causes the router to participate in the translator election process
when it attains border router status.
Format
area nssa translator-role
{always | candidate}
Mode Router OSPF Config
3.7.10.1 no area nssa translator-role (OSPF)
This command disables the nssa translator role from the specified area id.
Format
no area nssa translator-role
{always | candidate}
Mode Router OSPF Config
3.7.11 area nssa translator-stab-intv (OSPF)
This command configures the translator of the NSSA. The
is the period of time that an elected translator continues to
perform its duties after it determines that its translator status has been deposed by
another router.
Format
area nssa translator-stab-intv
Mode Router OSPF Config
3.7.11.1 no area nssa translator-stab-intv (OSPF)
This command disables the nssa translator’s from the specified
area id.
Format
no area nssa translator-stab-intv
val>
Mode Router OSPF Config
3.7.12 area range (OSPF)
This command creates a specified area range for a specified NSSA. The is a
valid IP address. The is a valid subnet mask. The LSDB type must be
specified by either
summarylink
or
nssaexternallink
, and the advertising of the area
range can be allowed or suppressed.
Format
area range {summarylink |
nssaexternallink} [advertise | not-advertise]
Mode Router OSPF Config
3.7.12.1 no area range
This command deletes a specified area range. The is a valid IP address. The
is a valid subnet mask.
Format
no area range
Mode Router OSPF Config