Kontron AT8904 CLI - Manual (Page 152)

Routing Commands AT8904M
AT8904M CLI Reference Manual Page 3 - 38
learnt by other protocols) or disabled (if the router is not configured
for the same).
RFC 1583 Compatibility Indicates whether 1583 compatibility is enabled or dis-
abled. This is a configured value.
ABR Status Shows whether the router is an OSPF Area Border Router.
Exit Overflow Interval The number of seconds that, after entering OverflowState, a
router will attempt to leave OverflowState.
External LSA Count The number of external (LS type 5) link-state advertisements in
the link-state database.
External LSA Checksum The sum of the LS checksums of external link-state adver-
tisements contained in the link-state database.
New LSAs Originated The number of new link-state advertisements that have been
originated.
LSAs Received The number of link-state advertisements received determined to be
new instantiations.
External LSDB Limit The maximum number of non-default AS-external-LSAs
entries that can be stored in the link-state database.
Default Metric Default value for redistributed routes.
Default Route Advertise Indicates whether the default routes received from other
source protocols are advertised or not
Always Shows whether default routes are always advertised.
Metric The metric for the advertised default routes. If the metric is not config-
ured, this field is blank.
Metric Type Shows whether the routes are External Type 1 or External Type 2.
Maximum Paths The maximum number of paths that OSPF can report for a given
destination.
Redistributing This field is a heading and appears only if you configure the system to
take routes learned from a non-OSPF source and advertise them to its
peers.
Source The source protocol/routes that are being redistributed. Possible values
are static, connected or RIP.
Metric The metric of the routes being redistributed.
Metric Type Shows whether the routes are External Type 1 or External Type 2.
Tag
The decimal value attached to each external route.
Subnets For redistributing routes into OSPF, the scope of redistribution for the
specified protocol.
Distribute-List The access list used to filter redistributed routes.
3.7.42 show ip ospf abr
This command displays the internal OSPF routing table entries to Area Border Routers
(ABR). This command takes no options.