Kontron AT8904 CLI - Manual (Page 150)

Routing Commands AT8904M
AT8904M CLI Reference Manual Page 3 - 36
Default enabled
Format
ip ospf mtu-ignore
Mode Interface Config
3.7.35.1 no ip ospf mtu-ignore
This command enables the OSPF MTU mismatch detection.
Format
no ip ospf mtu-ignore
Mode Interface Config
3.7.36 router-id (OSPF)
This command sets a 4-digit dotted-decimal number uniquely identifying the router
ospf id. The <
ipaddress
> is a configured value.
Format
router-id
Mode Router OSPF Config
3.7.37 redistribute (OSPF)
This command configures OSPF protocol to allow redistribution of routes from the
specified source protocol/routers.
Default
metric—unspecified
type—2
tag—0
Format
redistribute
{rip | static | connected} [metric <0-16777214>]
[metric-type {1 | 2}] [tag <0-4294967295>] [subnets]
Mode Router OSPF Config
3.7.37.1 no redistribute
This command configures OSPF protocol to prohibit redistribution of routes from the
specified source protocol/routers.
Format
no redistribute
{rip | static | connected} [metric] [metric-type]
[tag] [subnets]
Mode Router OSPF Config
3.7.38 maximum-paths (OSPF)
This command sets the number of paths that OSPF can report for a given destination
where
maxpaths
is platform dependent.
Default 4
Format
maximum-paths
Mode Router OSPF Config