Kontron AT8904 CLI - Manual (Page 197)

AT8904M Quality of Service (QoS) Commands
Page 4 - 29 AT8904M CLI Reference Manual
4.8.2 ip access-group
This command attaches a specified IP ACL to one interface or to all interfaces.
An optional sequence number may be specified to indicate the order of this IP access
list relative to other IP access lists already assigned to this interface and direction. A
lower number indicates higher precedence order. If a sequence number is already in use
for this interface and direction, the specified access list replaces the currently attached
IP access list using that sequence number. If the sequence number is not specified for
this command, a sequence number that is one greater than the highest sequence number
currently in use for this interface and direction is used.
Default none
Format
ip access-group in [sequence <1-
4294967295>]
Modes Interface Config
Global Config
4.8.2.1 no ip access-group
This command removes a specified IP ACL from an interface.
Default none
Format
no ip access-group in
Mode Interface Config
4.8.3 acl-trapflags
This command enables the ACL trap mode.
Default disabled
Format
acl-trapflags
Mode Global Config
4.8.3.1 no acl-trapflags
This command disables the ACL trap mode.
Format
no acl-trapflags
Mode Global Config
4.8.4 show ip access-lists
This command displays an IP ACL is the number used to
identify the IP ACL.
Format
show ip access-lists
Mode Privileged EXEC
NOTE: Only the access list fields that you configure are displayed.
Rule Number The number identifier for each rule that is defined for the IP ACL.