Kontron AT8904 CLI - Manual (Page 40)

Switching Commands AT8904M
AT8904M CLI Reference Manual Page 2 - 4
Format
no mtu
Mode Interface Config
2.1.6 shutdown
This command disables a port.
NOTE: You can use the
shutdown
command on physical and port-channel
(LAG) interfaces, but not on VLAN routing interfaces.
Default enabled
Format
shutdown
Mode Interface Config
2.1.6.1 no shutdown
This command enables a port.
Format
no shutdown
Mode Interface Config
2.1.7 shutdown all
This command disables all ports.
NOTE: You can use the
shutdown all
command on physical and port-chan-
nel (LAG) interfaces, but not on VLAN routing interfaces.
Default enabled
Format
shutdown all
Mode Global Config
2.1.7.1 no shutdown all
This command enables all ports.
Format
no shutdown all
Mode Global Config
2.1.8 speed
This command sets the speed and duplex setting for the interface.
Format
speed {<100 | 10> }
Mode Interface Config
Acceptable values are:
100h 100BASE-T half duplex
100f 100BASE-T full duplex
10h 10BASE-T half duplex
10f 10BASE-T full duplex