Kontron AT8904 CLI - Manual (Page 162)

Routing Commands AT8904M
AT8904M CLI Reference Manual Page 3 - 48
3.8 Routing Information Protocol (RIP) Commands
This section describes the commands you use to view and configure RIP, which is a
distance-vector routing protocol that you use to route traffic within a small network.
3.8.1 router rip
Use this command to enter Router RIP mode.
Format
router rip
Mode Global Config
3.8.2 enable (RIP)
This command resets the default administrative mode of RIP in the router (active).
Default
enabled
Format
enable
Mode Router RIP Config
3.8.2.1 no enable (RIP)
This command sets the administrative mode of RIP in the router to inactive.
Format
no enable
Mode Router RIP Config
3.8.3 ip rip
This command enables RIP on a router interface.
Default
disabled
Format
ip rip
Mode Interface Config
3.8.3.1 no ip rip
This command disables RIP on a router interface.
Format.
no ip rip
Mode Interface Config
3.8.4 auto-summary
This command enables the RIP auto-summarization mode.
Default
disabled
Format
auto-summary
Mode Router RIP Config
3.8.4.1 no auto-summary
This command disables the RIP auto-summarization mode.