Kontron AT8904 CLI - Manual (Page 128)

Routing Commands AT8904M
AT8904M CLI Reference Manual Page 3 - 14
3.3 Router Discovery Protocol Commands
This section describes the commands you use to view and configure Router Discovery
Protocol settings on the switch. The Router Discovery Protocol enables a host to
discover the IP address of routers on the subnet.
3.3.1 ip irdp
This command enables Router Discovery on an interface.
Default
disabled
Format
ip irdp
Mode Interface Config
3.3.1.1 no ip irdp
This command disables Router Discovery on an interface.
Format
no ip irdp
Mode Interface Config
3.3.2 ip irdp address
This command configures the address that the interface uses to send the router
discovery advertisements. The valid values for are 224.0.0.1, which is the
all-hosts IP multicast address, and 255.255.255.255, which is the limited broadcast
address.
Default
224.0.0.1
Format
ip irdp address
Mode Interface Config
3.3.2.1 no ip irdp address
This command configures the default address used to advertise the router for the
interface.
Format
no ip irdp address
Mode Interface Config
3.3.3 ip irdp holdtime
This command configures the value, in seconds, of the holdtime field of the router
advertisement sent from this interface. The holdtime range is the value of
to 9000 seconds.
Default 3 * maxinterval
Format
ip irdp holdtime
Mode Interface Config