Kontron AT8904 CLI - Manual (Page 227)

AT8904M Utility Commands
Page 5 - 27 AT8904M CLI Reference Manual
{xmodem | tftp:////}
For TFTP, the parameter is the IP address of the server, is the
path to the file, and is the name of the file you want to upload or
download.
5.6 Keying for Advanced Features
This section describes the commands you use to enter the licence key to access
advanced features. You cannot access the advanced features without a valid license
key.
Table 1. Copy Parameters
Source Destination Description
nvram:clibanner
Copies the CLI banner to a server.
nvram:errorlog
Copies the error log file to a server.
nvram:log
Copies the log file to a server.
nvram:script
Copies a specified configuration script
file to a server.
nvram:startup-con-
fig
Copies the startup configuration to a
server.
nvram:traplog
Copies the trap log file to a server.
system:running-
config
nvram:startup-
config
Saves the running configuration to
nvram.
nvram:clibanner
Downloads the CLI banner to the sys-
tem.
nvram:script
Downloads a configuration script file
to the system. During the download of
a configuration script, the copy com-
mand validates the script. In case of
any error, the command lists all the
lines at the end of the validation pro-
cess and prompts you to confirm before
copying the script file.
nvram:sshkey-dsa
Downloads an SSH key file. For more
information, see 6.4 “Secure Shell
(SSH) Command” on page 6 - 11.
nvram:sshkey-
rsa1
Downloads an SSH key file.
nvram:sshkey-
rsa2
Downloads an SSH key file.
nvram:startup-
config
Downloads the startup configuration
file to the system.
nvram:system-
image
Downloads a code image to the system.