Kontron AT8904 CLI - Manual (Page 203)

AT8904M Utility Commands
Page 5 - 3 AT8904M CLI Reference Manual
5.1.3 download frudata
This command updates the IPMI FRU data. It downloades a FRU image from
and updates the PM with the new FRU data. If the flash process is interrupted or fails,
FRU data may be corrupted and the download process has to be retried until it finishes
successfully.
Format
download frudata
Mode
Privileged EXEC
5.1.4 download fwum
This command updates the FWUM firmware. It downloads an FWUM firmware image
from URL and flashes the FWUM with the new image. If the flash process is
interrupted or fails, the FWUM will not recover gracefully and the board has to be
repaired manually.
Use this command with extreme care. It is not field safe.
Do not interrupt the upgrade process.
Format
download fwum
Modes
Privileged EXEC
5.1.5 download bootloader
This command loads a bootloader image into the second partition. It downloades a
bootloader image from . This image is used for the next boot process. If the
download fails or the image is not correct (CRC error) the image in the first parttion is
used.
Format
download bootloader
Mode
Privileged EXECEXEC
5.1.6 download amcipmifw
This command updates the IPMI firmware on an AMC. It downloads an IPMI
firmware image from URL and flashes the MMC on the AMC with the new image. If
the flash process is interrupted or fails, the MMC will automatically recover and use
the previously installed image.
Format
download amcimpifw {amcb1|amcb2}
Mode
Privileged EXEC
5.1.7 startupslot
This command configures the startup slot with the supplied values from the other slots.
It will also check the configuration for consistency and flag any errors. The slot
number () ranges from 0 - 9.
Format
startupslot config initrd
Mode
Global Config