Kontron AT8904 CLI - Manual (Page 264)

Management Commands AT8904M
AT8904M CLI Reference Manual Page 6 - 10
NOTE: Changing the timeout value for active sessions does not become effec-
tive until the session is reaccessed. Also, any keystroke activates the
new timeout duration.
Format
no telnetcon timeout
Mode Privileged EXEC
6.3.9 disconnect
Use the
disconnect
command to close Telnet or SSH sessions. Use all to close all
Telnet and SSH sessions, or use to specify the session ID to close. To
view the possible values for , use the
show loginsession
command.
Format
disconnect
{ | all}
Mode Privileged EXEC
6.3.10 show loginsession
This command displays current Telnet and serial port connections to the switch.
Format
show loginsession
Mode Privileged EXEC
ID Login Session ID
User Name The name the user will use to login using the serial port or Telnet.
Connection From IP address of the Telnet client machine or EIA-232 for the serial
port connection.
Idle Time Time this session has been idle.
Session Time Total time this session has been connected.
6.3.11 show telnet
This command displays the current outbound Telnet settings. In other words, these
settings apply to Telnet connections initiated from the switch to a remote system.
Format
show telnet
Modes Privileged EXEC
User EXEC
Outbound Telnet Login Timeout The number of minutes an outbound Telnet session
is allowed to remain inactive before being logged off.
Maximum Number of Outbound Telnet Sessions The number of simultaneous out-
bound Telnet connections allowed.
Allow New Outbound Telnet Sessions Indicates whether outbound Telnet sessions
will be allowed.
6.3.12 show telnetcon
This command displays the current inbound Telnet settings. In other words, these
settings apply to Telnet connections initiated from a remote system to the switch.
Format
show telnetcon
Modes Privileged EXEC