Kontron AT8904 CLI - Manual (Page 191)

AT8904M Quality of Service (QoS) Commands
Page 4 - 23 AT8904M CLI Reference Manual
4.6.6 show policy-map interface
This command displays policy-oriented statistics information for the specified
interface and direction. The
<
slot/port
>
parameter specifies a valid interface for the
system.
NOTE: This command is only allowed while the DiffServ administrative
mode is enabled.
Format
show policy-map interface <slot/port> [in]
Mode Privileged EXEC
Interface Valid slot and port number separated by forward slashes.
Direction The traffic direction of this interface service.
Operational Status The current operational status of this DiffServ service interface.
Policy Name The name of the policy attached to the interface in the indicated direc-
tion.
The following information is repeated for each class instance within this policy:
Class Name The name of this class instance.
In Discarded Packets A count of the packets discarded for this class instance for any
reason due to DiffServ treatment of the traffic class.
4.6.7 show service-policy
This command displays a summary of policy-oriented statistics information for all
interfaces in the specified direction.
Format
show service-policy in
Mode Privileged EXEC
The following information is repeated for each interface and direction (only those
interfaces configured with an attached policy are shown):
Interface Valid slot and port number separated by forward slashes.
Operational Status The current operational status of this DiffServ service interface.
Policy Name The name of the policy attached to the interface
4.7 MAC Access Control List (ACL) Commands
This section describes the commands you use to configure MAC ACL settings. MAC
ACLs ensure that only authorized users have access to specific resources and block any
unwarranted attempts to reach network resources.
The following rules apply+-to MAC ACLs:
• The maximum number of ACLs you create is 100, regardless of type.
• The system supports only Ethernet II frame types.
• The maximum number of rules per MAC ACL is hardware dependent.
• For the Broadcom 5630x platform, if you configure an IP ACL on an interface, you
cannot configure a MAC ACL on the same interface.