Kontron AT8904 CLI - Manual (Page 275)

AT8904M Management Commands
Page 6 - 21 AT8904M CLI Reference Manual
NOTE: This command does not support a “no” form.
Default snmpv2
Format
snmptrap snmpversion
Mode Global Config
6.6.16 snmptrap ipaddr
This command assigns an IP address to a specified community name. The maximum
length of name is 16 case-sensitive alphanumeric characters.
NOTE: IP addresses in the SNMP trap receiver table must be unique. If you
make multiple entries using the same IP address, the first entry is
retained and processed. All duplicate entries are ignored.
Format
snmptrap ipaddr
Mode Global Config
6.6.17 snmptrap mode
This command activates or deactivates an SNMP trap. Enabled trap receivers are active
(able to receive traps). Disabled trap receivers are inactive (not able to receive traps).
Format
snmptrap mode
Mode Global Config
6.6.17.1 no snmptrap mode
This command deactivates an SNMP trap. Disabled trap receivers are unable to receive
traps.
Format
no snmptrap mode
Mode Global Config
6.6.18 snmp trap link-status
This command enables link status traps by interface.
NOTE: This command is valid only when the Link Up/Down Flag is enabled.
“snmp-server enable traps linkmode” on page 6 - 19.
Format
snmp trap link-status
Mode Interface Config
6.6.18.1 no snmp trap link-status
This command disables link status traps by interface.
NOTE: This command is valid only when the Link Up/Down Flag is enabled.
See 6.6.11 “snmp-server enable traps linkmode” on page 6 - 19).
Format
no snmp trap link-status
Mode Interface Config