Kontron AT8904 CLI - Manual (Page 194)

Quality of Service (QoS) Commands AT8904M
AT8904M CLI Reference Manual Page 4 - 26
4.7.4 mac access-group
This command attaches a specific MAC Access Control List (ACL) identified by
to an interface in a given direction. The parameter must be the name of
an existing MAC ACL.
An optional sequence number may be specified to indicate the order of this mac access
list relative to other mac access lists already assigned to this interface and direction. A
lower number indicates higher precedence order. If a sequence number is already in use
for this interface and direction, the specified mac access list replaces the currently
attached mac access list using that sequence number. If the sequence number is not
specified for this command, a sequence number that is one greater than the highest
sequence number currently in use for this interface and direction is used.
This command specified in 'Interface Config' mode only affects a single interface,
whereas the 'Global Config' mode setting is applied to all interfaces. The 'Interface
Config' mode command is only available on platforms that support independent per-
port class of service queue configuration.
Format
mac access-group in [sequence <1-4294967295>]
Modes Global Config
Interface Config
4.7.4.1 no mac access-group
This command removes a MAC ACL identified by from the interface in a
given direction.
Format
no mac access-list in
Modes Global Config
Interface Config
4.7.5 show mac access-lists
This command displays a MAC access list and all of the rules that are defined for the
MAC ACL. Use the
[name]
parameter to identify a specific MAC ACL to display.
Format
show mac access-lists [name]
Mode Privileged EXEC
Rule Number The ordered rule number identifier defined within the MAC ACL.
Action
The action associated with each rule. The possible values are Permit or
Deny.
Source MAC Address The source MAC address for this rule.
Destination MAC Address The destination MAC address for this rule.
Ethertype
The Ethertype keyword or custom value for this rule.
VLAN ID The VLAN identifier value or range for this rule.
COS The COS (802.1p) value for this rule.
Log Displays when you enable logging for the rule.
Assign Queue The queue identifier to which packets matching this rule are assigned.