Kontron AT8904 CLI - Manual (Page 205)

AT8904M Utility Commands
Page 5 - 5 AT8904M CLI Reference Manual
5.2.3 set board fcap
This command enables or disables some firmware capabilities. If the handle capability
is enabled, the hardware handle is ignored.
Format
set board fcap handle enable
set board fcap handle disable
Mode
Privileged EXEC
5.2.4 show boardinfo fcap
This command shows the user changeable firmware capabilities.
Format
show boardinfo fcap
Mode
Privileged EXEC
5.2.5 set board routing
This commands sets which interface should be configured with layer 3 functionality.
This becomes effective after the next reboot. You should use for this reboot the factory
defaults for the configuration to avoid inconsistency (layer 3 commands may be
implemented in the current configuration for the fabric interface which reboots without
layer 3 functionality).
Format
set board routing base
set board routing extension
set board routing none
Mode
Privileged EXEC
5.2.6 show boardinfo routing
This commands shows which interface is configured with Layer 3 functionality. It
shows the currently active setting and the setting which becomes effective after the
next reboot.
Format
show boardinfo routing
Mode
Privileged EXEC
5.2.7 ekeying
This command enables the ekeying for one port. By default, ekeying is enabled
Format
ekeying
Mode
Interface Config
5.2.7.1 no ekeying
This command disables the ekeying for one port. .
Format
no ekeying
Mode
Interface Config