Kontron AT8904 CLI - Manual (Page 237)

AT8904M Utility Commands
Page 5 - 37 AT8904M CLI Reference Manual
Default
inbound interface helper addresses
Format
next-server
Mode
DHCP Pool Config
5.8.14.1 no next-server
This command removes the boot server list.
Format
no next-server
Mode
DHCP Pool Config
5.8.15 option
The
option
command configures DHCP Server options. The <
code
> parameter
specifies the DHCP option code and ranges from 1-254. The
parameter specifies an NVT ASCII character string. ASCII character strings that
contain white space must be delimited by quotation marks. The
hex
parameter specifies hexadecimal data. In hexadecimal, character strings are two
hexadecimal digits. You can separate each byte by a period (for example, a3.4f.22.0c),
colon (for example, a3:4f:22:0c), or white space (for example, a3 4f 22 0c).
Default
none
Format
option {ascii string | hex
[...] | ip
[...]}
Mode
DHCP Pool Config
5.8.15.1 no option
This command removes the DHCP Server options. The <
code
> parameter specifies the
DHCP option code.
Format
no option
Mode
DHCP Pool Config
5.8.16 ip dhcp excluded-address
This command specifies the IP addresses that a DHCP server should not assign to
DHCP clients. Low-address and high-address are valid IP addresses; each made up of
four decimal bytes ranging from 0 to 255. IP address 0.0.0.0 is invalid.
Default
none
Format
ip dhcp excluded-address [highaddress]
Mode
Global Config
5.8.16.1 no ip dhcp excluded-address
This command removes the excluded IP addresses for a DHCP client. Low-address and
high-address are valid IP addresses; each made up of four decimal bytes ranging from
0 to 255. IP address 0.0.0.0 is invalid.
Format
no ip dhcp excluded-address [highaddress]