Kontron AT8904 CLI - Manual (Page 117)

AT8904M Routing Commands
Page 3 - 3 AT8904M CLI Reference Manual
3.1.2 ip proxy-arp
This command enables proxy ARP on a router interface. Without proxy ARP, a device
only responds to an ARP request if the target IP address is an address configured on the
interface where the ARP request arrived. With proxy ARP, the device may also respond
if the target IP address is reachable. The device only responds if all next hops in its
route to the destination are through interfaces other than the interface that received the
ARP request.
Default
enabled
Format
ip proxy-arp
Mode Interface Config
3.1.2.1 no ip proxy-arp
This command disables proxy ARP on a router interface.
Format
no ip proxy-arp
Mode Interface Config
3.1.3 arp cachesize
This command configures the ARP cache size. The ARP cache size value is a platform
specific integer value. The default size also varies depending on the platform.
Format
arp cachesize
Mode Global Config
3.1.3.1 no arp cachesize
This command configures the default ARP cache size.
Format
no arp cachesize
Mode Global Config
3.1.4 arp dynamicrenew
This command enables the ARP component to automatically renew dynamic ARP
entries when they age out.
Default
enabled
Format
arp dynamicrenew
Mode Privileged EXEC
3.1.4.1 no arp dynamicrenew
This command prevents dynamic ARP entries from renewing when they age out.
Format
no arp dynamicrenew
Mode Privileged EXEC