Kontron AT8904 CLI - Manual (Page 196)

Quality of Service (QoS) Commands AT8904M
AT8904M CLI Reference Manual Page 4 - 28
4.8.1.1 no access-list
This command deletes an IP ACL that is identified by the parameter
<
accesslistnumber>
from the system. The range for <
accesslistnumber>
1-99 for
standard access lists and 100-199 for extended access lists.
Format
no access-list
Mode Global Config
Table 2. ACL Command Parameters
Parameter Description
<1-99> or <100-199>
Range 1 to 99 is the access list number for an IP standard
ACL. Range 100 to 199 is the access list number for an
IP extended ACL.
{deny | permit}
Specifies whether the IP ACL rule permits or denies an
action.
Note: For 5630x and 5650x-based systems, assign-queue,
redirect, and mirror attributes are configurable for a deny
rule, but they have no operational effect.
every
Match every packet
{icmp | igmp | ip | tcp
| udp | }
Specifies the protocol to filter for an extended IP ACL
rule.
Specifies a source IP address and source netmask for
match condition of the IP ACL rule.
[{eq { |
<0-65535>}]
Specifies the source layer 4 port match condition for the
IP ACL rule. You can use the port number, which ranges
from 0-65535, or you specify the
, which can
be one of the following keywords:
domain, echo,
ftp, ftpdata, http, smtp, snmp, telnet,
tftp
, and
www
. Each of these keywords translates into its
equivalent port number, which is used as both the start
and end of a port range.
Specifies a destination IP address and netmask for match
condition of the IP ACL rule.
[precedence
dence> | tos
| dscp ]
Specifies the TOS for an IP ACL rule depending on a
match of precedence or DSCP values using the parame-
ters
dscp
,
precedence
,
tos/tosmask
.
[log]
Specifies that this rule is to be logged.
[assign-queue
id>]
Specifies the assign-queue, which is the queue identifier
to which packets matching this rule are assigned.
[{mirror | redirect}
]
For Broadcom 5650x platforms, specifies the mirror or
redirect interface which is the slot/port to which packets
matching this rule are copied or forwarded, respectively.
The
mirror
and
redirect
parameters are not available
on the Broadcom 5630x platform.