Kontron AT8904 CLI - Manual (Page 217)

AT8904M Utility Commands
Page 5 - 17 AT8904M CLI Reference Manual
5.3.10 show tech-support
Use the
show tech-support
command to display system and configuration
information when you contact technical support. The output of the
show tech-
support
command combines the output of the following commands:
• show version
• show sysinfo
• show port all
• show logging
• show event log
• show logging buffered
• show trap log
• show running config
Format
show tech-support
Mode
Privileged EXEC
5.3.11 show boardinfo post-status
This command displays the system power on self test status.
Format
show boardinfo post-status system
Mode
Privileged EXEC
5.3.12 show boardinfo sensors
This command displays the current sensor readings. It can either display a compressed
list of all sensors or display full readings for a specified sensor. The (of
SDR) for a specific sensor is displayed in the compressed list
Format
show boardinfo sensors { | brief}
Mode
Privileged EXEC
NOTE: It might take a while to get an output of the “show boardinfo sensors brief”
command
5.3.13 show boardinfo event-log
This command displays the event log of the board management controller. It can either
display a summary (“info”) or a list of all existing event-log records, a list with most
recent records or a single record. The (of SEL) is displayed in the list of
records.
Format
show boardinfo event-log {info | list [last
recent-entries> | ]}
Mode
Privileged EXEC
NOTE: It might take a while to get an output of the “show boardinfo event-log list”
command
5.3.14 show boardinfo update-status
This command displays the status of the firmware update process for the IPMI
controller.