Kontron AT8904 CLI - Manual (Page 132)

Routing Commands AT8904M
AT8904M CLI Reference Manual Page 3 - 18
3.5.2.1 no ip vrrp
Use this command in Interface Config mode to delete the virtual router associated with
the interface. The virtual Router ID, , is an integer value that ranges from 1 to
255.
Format
no ip vrrp
Mode Interface Config
3.5.3 ip vrrp mode
This command enables the virtual router configured on the specified interface.
Enabling the status field starts a virtual router. The parameter is the virtual
router ID which has an integer value ranging from 1 to 255.
Default
disabled
Format
ip vrrp mode
Mode Interface Config
3.5.3.1 no ip vrrp mode
This command disables the virtual router configured on the specified interface.
Disabling the status field stops a virtual router.
Format
no ip vrrp mode
Mode Interface Config
3.5.4 ip vrrp ip
This command sets the virtual router IP address value for an interface. The value for
is the IP address which is to be configured on that interface for VRRP. The
parameter is the virtual router ID which has an integer value range from 1 to
255. You can use the optional
[secondary]
parameter to designate the IP address as a
secondary IP address.
Default
none
Format
ip vrrp ip
[secondary]
Mode Interface Config
3.5.4.1 no ip vrrp ip
Use this command in Interface Config mode to delete a secondary IP address value
from the interface. To delete the primary IP address, you must delete the virtual router
on the interface.
Format
no ip vrrp
secondary
Mode Interface Config
3.5.5 ip vrrp authentication
This command sets the authorization details value for the virtual router configured on a
specified interface. The parameter
{none | simple}
specifies the authorization type
for virtual router configured on the specified interface. The parameter
[key]
is