Kontron AT8904 CLI - Manual (Page 133)

AT8904M Routing Commands
Page 3 - 19 AT8904M CLI Reference Manual
optional, it is only required when authorization type is simple text password. The
parameter is the virtual router ID which has an integer value ranges from 1 to
255.
Default
no authorization
Format
ip vrrp authentication
{none | simple }
Mode Interface Config
3.5.5.1 no ip vrrp authentication
This command sets the default authorization details value for the virtual router
configured on a specified interface.
Format
no ip vrrp authentication
Mode Interface Config
3.5.6 ip vrrp preempt
This command sets the preemption mode value for the virtual router configured on a
specified interface. The parameter is the virtual router ID, which is an integer
from 1 to 255
Default
enabled
Format
ip vrrp preempt
Mode Interface Config
3.5.6.1 no ip vrrp preempt
This command sets the default preemption mode value for the virtual router configured
on a specified interface.
Format
no ip vrrp preempt
Mode Interface Config
3.5.7 ip vrrp priority
This command sets the priority of a router within a VRRP group. Higher values equal
higher priority. The range is from 1 to 254. The parameter is the virtual router
ID whose range is from 1 to 255.
The router with the highest priority is elected master. If a router is configured with the
address used as the address of the virtual router, the router is called the “address
owner.” The priority of the address owner is always 255 so that the address owner is
always master. If the master has a priority less than 255 (it is not the address owner)
and you configure the priority of another router in the group higher than the master’s
priority, the router will take over as master only if preempt mode is enabled.
Default
100 unless the router is the address owner, in which case its priority is
automatically set to 255.
Format
ip vrrp priority
<1-254>
Mode Interface Config