Kontron AT8904 CLI - Manual (Page 245)

AT8904M Utility Commands
Page 5 - 45 AT8904M CLI Reference Manual
5.10.5.1 no port-channel hash unicast enhanced
This command disables enhanced unicast hash algorithm on the extension fabric
interface.
Format
no port-channel hash unicast enhanced mpls
no port-channel hash unicast enhanced ipv4-in-ip
no port-channel hash unicast enhanced ipv6-in-ip
no port-channel hash unicast enhanced ipv4-in-gre
no port-channel hash unicast enhanced ipv6-in-gre
Mode
Global Config
5.10.6 multicast (interface)
This command configures the port based multicast handling. The command defines the
handling for port specific unregistered multicast addresses. The default handling in
FASTPATH is that such packets are flooded (argument ‘default’). The user can change
the behaviour that such packets are dropped (argument ‘none’). The flooding mode is
set per port. It can be applied to either individual physical ports or to a port-channel.
Format
multicast flood default
multicast flood none
Mode
Interface Config
5.10.7 show port multicast
This command displays the port based multicast handling. The commands displays for
a specified interface or all interfaces the multicast flooding settings. The displayed
fields are
• the interface
• the multicast flooding, indicating whether a packet with unregistered multicast
address should be flooded or not (yes/no).
Format
show port multicast
show port multicast all
Mode
Privileged Exec
5.10.8 multicast (VLAN)
This command configures the VLAN based multicast handling. The command defines
the handling for VLAN based unregistered multicast addresses. The default handling in
FASTPATH is that such packets are flooded (argument ‘default’). The user can change
the behaviour that such packets are dropped (argument ‘none’). The flooding mode is
set per VLAN, the VLAN ID range is 1-4094. If a created VLAN is deleted again, the
flooding mode is reset to default.
Format
multicast <1-4094> flood default
multicast <1-4094> flood none
Mode
VLAN Config