Kontron AT8904 CLI - Manual (Page 274)

Management Commands AT8904M
AT8904M CLI Reference Manual Page 6 - 20
6.6.12.1 no snmp-server enable traps multiusers
This command disables Multiple User traps.
Format
no snmp-server enable traps multiusers
Mode Global Config
6.6.13 snmp-server enable traps stpmode
This command enables the sending of new root traps and topology change notification
traps.
Default enabled
Format
snmp-server enable traps stpmode
Mode Global Config
6.6.13.1 no snmp-server enable traps stpmode
This command disables the sending of new root traps and topology change notification
traps.
Format
no snmp-server enable traps stpmode
Mode Global Config
6.6.14 snmptrap
This command adds an SNMP trap receiver. The maximum length of is 16
case-sensitive alphanumeric characters. The is the version of SNMP.
The version parameter options are snmpv1 or snmpv2.
NOTE: The parameter does not need to be unique, however; the
and pair must be unique. Multiple entries can exist
with the same , as long as they are associated with a different
. The reverse scenario is also acceptable. The is the
community name used when sending the trap to the receiver, but the
is not directly associated with the SNMP Community Table,
See 6.6.2 “snmp-server community” on page 6 - 16.
Default snmpv2
Format
snmptrap
[snmpversion ]
Mode Global Config
6.6.14.1 no snmptrap
This command deletes trap receivers for a community.
Format
no snmptrap
Mode Global Config
6.6.15 snmptrap snmpversion
This command modifies the SNMP version of a trap. The maximum length of
is 16 case-sensitive alphanumeric characters. The parameter options
are snmpv1 or snmpv2.