Kontron AT8904 CLI - Manual (Page 226)

Utility Commands AT8904M
AT8904M CLI Reference Manual Page 5 - 26
Mode
Privileged EXEC
5.5.12.1 no set bootstopkey
This command resets the bootstop key. The boot process can not be interrupted.
Format
no set bootstopkey
Mode
Privileged EXEC
5.5.13 ping
This command checks if another computer is on the network and listens for
connections. To use this command, configure the switch for network (in-band)
connection. The source and target devices must have the ping utility enabled and
running on top of TCP/IP. You can ping the switch from any IP workstation the switch
is connected to through the default VLAN (VLAN 1), as long as there is a physical
path between the switch and the workstation. The terminal interface sends three pings
to the target station.
Format
ping
Modes
Privileged EXEC
User EXEC
5.5.14 quit
This command closes the current telnet connection or resets the current serial
connection. The system asks you whether to save configuration changes before
quitting.
Format
quit
Modes
Privileged EXEC
User EXEC
5.5.15 reload
This command resets the switch without powering it off. Reset means that all network
connections are terminated and the boot code executes. The switch uses the stored
configuration to initialize the switch. You are prompted to confirm that the reset should
proceed. The LEDs on the switch indicate a successful reset.
Format
reload
Mode
Privileged EXEC
5.5.16 copy
The
copy
command uploads and downloads files to and from the switch by using TFTP
or Xmodem.
Format
copy
Mode
Privileged EXEC
Replace the and parameters with the options in Table 1. For
the source or destination, use one of the following values: