Kontron AT8904 CLI - Manual (Page 134)

Routing Commands AT8904M
AT8904M CLI Reference Manual Page 3 - 20
3.5.7.1 no ip vrrp priority
This command sets the default priority value for the virtual router configured on a
specified interface.
Format
no ip vrrp priority
Mode Interface Config
3.5.8 ip vrrp timers advertise
This command sets the frequency, in seconds, that an interface on the specified virtual
router sends a virtual router advertisement.
Default
1
Format
ip vrrp timers advertise
<1-255>
Mode Interface Config
3.5.8.1 no ip vrrp timers advertise
This command sets the default virtual router advertisement value for an interface.
Format
no ip vrrp timers advertise
Mode Interface Config
3.5.9 show ip vrrp interface stats
This command displays the statistical information about each virtual router configured
on the FASTPATH switch.
Format
show ip vrrp interface stats
<slot/port>
Modes Privileged EXEC
User EXEC
Uptime The time that the virtual router has been up, in days, hours, minutes
and seconds.
Protocol The protocol configured on the interface.
State Transitioned to Master The total number of times virtual router state has
changed to MASTER.
Advertisement Received The total number of VRRP advertisements received by this
virtual router.
Advertisement Interval Errors The total number of VRRP advertisements received
for which advertisement interval is different than the configured value
for this virtual router.
Authentication Failure The total number of VRRP packets received that don't pass
the authentication check.
IP TTL errors The total number of VRRP packets received by the virtual router with
IP TTL (time to live) not equal to 255.
Zero Priority Packets Received The total number of VRRP packets received by vir-
tual router with a priority of '0'.