AVer XR8032_RACK - Manual (Page 74)

68
3.9.1 To Setup Alarm Relay:
1. Beside the Relay Output check box, click Detail.
2. In the Alarm Relay dialog box, select from the available relay
list and in the ON column, set to enable/disable the relay
operation when the alarm is activated.
3. In the Retrieve time check box, you may enable/disable to
extend the relay operation time and set the duration in second.
4. Click OK to exit and accept the setting and Cancel to exit
without saving the setting.
3.9.2 To Setup the Alarm Sound Setting
1. Beside the Play Warning Sound check box, click Detail.
2. In the Alarm Sound Setting dialog box, click
to select
other wav file from other source or folder, Play to listen, Record
to make a new copy of a sound.
3. If you click Record, you will be prompted if you want to replace
the file. Click OK to continue and Cancel to discontinue.
4. When the Sound Recorder appears, use the record control
panel to record, stop, play, rewind and forward. If you want to
keep the existing file, click File > Save As…, enter filename
and click Save. Make sure you have microphone connected to
your PC.
5. Click OK to exit and accept the setting and click Cancel to exit
without saving the setting.
3.9.3 To Setup Call Out List:
1. Beside the Make Phone Calls check box, click
Detail.
2. In the Call Out List, click Add to insert a new contact
number, click Modify to edit the selected item, click
Remove to delete the selected item, click Test to
check if it is working.
3. In the Call Out Setting, enter the Phone Number
and Description. Click to select existing sound
recorded massager and Record to make a new
voice message.
4. When the Sound Recorder appears, use the record
control panel to record, stop, play, rewind and
forward. If you want to keep the existing file, click
File > Save As…, enter filename and click Save.
Make sure you have microphone connected to your
PC.
5. The supported audio system is only 8KHz and 16Bit
mono.
6. Click OK to exit and accept the setting and Cancel to
exit without saving the setting.