AVer XR8032_RACK User Manual
Page 71
65
alarm message.
• Network is switched off: when the network connection of DVR system is lost, the system will send
out the alarm message.
• Hard Disk failed: when the hard disk can’t work normally, the system will send out the alarm
message.
• Temperature: set a temperature limited of system for system to alarm. When DVR system
temperature is over the temperature limited, the system will send out the alarm. The system
supports °C and °F temperature mode.
• Illegal Entry: any objects move between selected regions which user has set up in Object
Counting
section (see
3.2.1
), the system will send out the alarm. Select the entry (object moves
from region 1 to 2 or from region 2 to 1) and and click the Detail to select the camera and the times
for system alarm.
9
Trigger if once: Send out the alarm when the selected camera match the illegal entry has
selected.
9
Trigger if the amount exceeds:
Send out the alarm when the selected camera and illegal entry
times match the illegal entry has selected.
i
Only the camera has been setup in Object Counting will be available for selecting in Illegal
Entry
.
• FaceFinder: Enable to send out the alarm when the selected channel has detected face.
i
Only the camera has setup FaceFinder detection will be available for selecting.
- Enable/disable the POS Keyword check box, to scan the data from the POS if it matches the keyword
(see also
3.9.11
).
- Alarm Message: Enable/disable to active with external alarm message by your own program. For the
detail configuration, please contact the local reseller.
- Alarm Button: Enable/disable to active manual alarm function (see also
Chapter 2.2#(19)
). To define
alarm message of manually alarm trigger. Click alarm button and select the alarm button # and fill in the
description of alarm button.
6. In
(5) Alarm Reset
, click the camera number (01 to 16) to set the reset condition of alarm. Once alarm is
reset, all alarm action will stop at the moment. If the sensor normal status is high, set the sensor condition
to low.
Click IP Cam Sensor to IP camera sensor reset condition. Click High or Low column to set the reset
condition of alarm.