AVer XR8032_RACK - Manual (Page 72)

66
- Alarm Reset Time: Set a time for the alarm auto reset. When an alarm happen such as motion detected
and video loss, the alarm will reset at the alarm reset time.
7. In
(6) Priority
, set the priority of this alarm set.
8. In (7) Action , you may now set the alarm action for the system to perform when the alarm condition is
activated.
- Launch E-Map
Display mini Emap screen.
- TV Out
Switch to only display the video on TV from where the alarm is activated.
- Enlarge Camera View
Switch to only display video in Preview/Advanced mode from where the alarm is activated.
a. Select the camera from drop down list to specify which camera video to be enlarged on screen
when the alarm is triggered.
~ Alarm Camera:
when a channel has an alarm occurred, and then, the channel video that has an
alarm occurred will be enlarged on screen.
~ Camera # (1~32): the selected channel video that will be enlarged on screen when an alarm is
activated.
b. Select the display mode – 1 Channel or Full Screen.
c. Retrieve time: set the waiting duration before system switching back to original Preview mode. If
the retrieve time is un-mark, the alarm video will keep enlarging until user switch back to Preview
mode manually. The retrieve time range is 3~ 600 seconds.
- Relay Output
Set to enable/disable the relay operation when the alarm is activated and to extend additional time in
second before it stops the relay operation (see also
3.9.1 ).
- IP Camera Relay
Set to enable/disable IP camera relay trigger. Click ON column to enable/disable the relay trigger. The
blank column means the trigger is off.