AVer XR8032_RACK - Manual (Page 135)

129
12. In (3) Conditions, you can set “Trigger if any” to activate if it falls to one of the conditions or “Trigger if all”
to activate if it falls to all conditions.
13. In (4) Camera section , select and click on the camera number (01 to 32) in Motion Detected and Video
Loss to set the condition for the system to alarm.
9 In
Missing and Suspicious Object Detected
, click the camera number (01 to 32) and select the certain
object on the screen, and when the certain object is missing or doubtful, the system will alarm. (see also
Chapter 3.9.12 ) In Scene Change, when the camera has been moved, the system will alarm, too.
9 In
Audio Detection
, click the camera number (01 to 32) to the system to alarm when detect the
abnormal voice.
14. In (5) Sensor , select and click on the sensor number (use W and X to select the sensor) to set the
condition for the system to alarm. If the sensor normal status is high, set the sensor condition to low.
9
Abnormal Event: Enable/disable to set the condition of the event for system to alarm.
• System Reboot: when the DVR system reboot without abnormal condition, the system will send
out the alarm message.
• Abnormal Reboot: when the DVR system reboot in irregular condition, the system will send out the
alarm message.
• Recording is switched off: when the recording has been stopped, the system will send out the
alarm message.
• Network is switched off: when the network connection of DVR system is lost, the system will send
out the alarm message.
• Hard Disk failed: when the hard disk can’t work normally, the system will send out the alarm
message.
9 POS Keyword: Enable/disable to scan the data from the POS if it matches the keyword (see also
Chapter 3.9.11 ).
9 Alarm Message: Enable/disable to active with external alarm message by your own program. For the
detail configuration, please contact the local reseller.