Table 42 – Dell POWEREDGE M1000E User Manual
Page 221
Fabric OS Administrator’s Guide
181
53-1001763-02
Configuration file restoration
8
In case something happens to your switch and you need to set it up again, run the commands listed
in
and save the output in a file format. Store the files in a safe place for emergency
reference.
-all
The number of switches or FIDs defined in the downloaded configuration file
must match the number of switches or FIDs currently defined on the switch.
The switches must be disabled, if necessary (refer to
on page 182 for more information on non-disruptive
configuration downloads). If they are not, the configDownload command
downloads the configuration for as many switches as possible until a
non-disabled switch is encountered. Then it will stop. Before running this
command, verify if any switches need to be disabled. If you are performing a
configDownload due to a configuration error, it is highly recommended to
perform a configDefault before running the configDownload command.
In Virtual Fabric-enabled mode, the chassisDisable and chassisEnable
commands are used to disable all logical switches on the affected switch. This
bypasses the need to disable and enable each switch individually once the
configuration download has completed.
Non-Virtual Fabric configuration files downloaded to a Virtual Fabric system will
only have configuration applied to the default switch. If there are multiple logical
switches created in a Virtual Fabric-enabled system, there could be some issues
if there are ports that belong to the default switch in a Virtual Fabric-disabled
system, but are now assigned to logical switches in a Virtual Fabric-enabled
system. Only configurations related to ports within the default switch will be
applied.
TABLE 42
CLI commands to display or modify switch configuration information
Command
Displays
configShow
System configuration parameters and settings, and license information.
fcLunQuery
A list of LUN IDs and LUNs for all accessible targets.
fcrRouterPortCost
FC Router route information.
fcrXlateConfig
A translate (xlate) domain's domain ID for both EX_Port-attached fabric and backbone fabric.
fosConfig
Fabric OS features.
ipAddrShow
The IP address.
iscsiCfg
iSCSI entities.
iscsiPortCfg
The iSCSI port parameters.
iscsiTargetName
The IQN prefix.
isnscCfg
The configuration state of the iSNS client operation.
licenseShow
The license keys you have installed and provides better detail than the license information
from the configShow command.
portCfgEXPort
EX_Port configuration parameters.
portCfgVEXPort
VEX_Port configuration parameters.