Dell POWEREDGE M1000E - Manual (Page 307)

Fabric OS Administrator’s Guide 267
53-1001763-02
Chapter
12
Traffic Isolation Zoning
In this chapter
• Traffic Isolation Zoning overview . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 267
• Enhanced TI zones . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 272
• Traffic Isolation Zoning over FC routers . . . . . . . . . . . . . . . . . . . . . . . . . . . . 273
• General rules for TI zones . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 276
• Supported configurations for Traffic Isolation Zoning. . . . . . . . . . . . . . . . . 277
• Limitations and restrictions of Traffic Isolation Zoning. . . . . . . . . . . . . . . . 278
• Admin Domain considerations for Traffic Isolation Zoning. . . . . . . . . . . . . 279
• Virtual Fabric considerations for Traffic Isolation Zoning . . . . . . . . . . . . . . 279
• Traffic Isolation Zoning over FC routers with Virtual Fabrics . . . . . . . . . . . 281
• Creating a TI zone . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 282
• Modifying TI zones. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 284
• Changing the state of a TI zone . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 285
• Deleting a TI zone . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 286
• Displaying TI zones . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 286
• Setting up TI over FCR (sample procedure) . . . . . . . . . . . . . . . . . . . . . . . . . 287
Traffic Isolation Zoning overview
The Traffic Isolation Zoning feature allows you to control the flow of interswitch traffic by creating a
dedicated path for traffic flowing from a specific set of source ports (N_Ports). For example, you
might use Traffic Isolation Zoning for the following scenarios:
• To dedicate an ISL to high priority, host-to-target traffic.
• To force high volume, low priority traffic onto a given ISL to limit the effect on the fabric of this
high traffic pattern.
• To ensure that requests and responses of FCIP-based applications such as tape pipelining use
the same VE_Port tunnel across a metaSAN.
Traffic Isolation Zoning does not require a license.
Traffic isolation is implemented using a special zone, called a Traffic Isolation zone (TI zone). A TI
zone indicates the set of N_Ports and E_Ports to be used for a specific traffic flow. When a TI zone
is activated, the fabric attempts to isolate all inter-switch traffic entering from a member of the
zone to only those E_Ports that have been included in the zone. The fabric also attempts to exclude
traffic not in the TI zone from using E_Ports within that TI zone.