beautypg.com

Pci express cards, Pci express x16 card, Removing a pci card – Dell OptiPlex GX280 User Manual

Page 88

background image

b. Connect the network cable to the add-in network adapter's connectors. Do not connect the network cable to the

integrated connector on the back panel.

14. Install any drivers required for the card as described in the card documentation.

Removing a PCI Card

1. Follow the procedures in "

Before You Begin

."

2. Press the lever on the card retention arm and raise the retention arm.

3. If necessary, disconnect any cables connected to the card.

4. Grasp the card by its top corners, and ease it out of its connector.

5. If you are removing the card permanently, install a filler bracket in the empty card-slot opening.

If you need a filler bracket,

contact Dell

.

NOTE:

Installing filler brackets over empty card-slot openings is necessary to maintain FCC certification of the

computer. The brackets also keep dust and dirt out of your computer.

6. Lower the retention arm and press it into place.

NOTICE:

To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.

7. Close the computer cover, reconnect the computer and devices to electrical outlets, and turn them on.

After you open and close the cover, the chassis intrusion detector, if installed and enabled, causes the following

message to appear on the screen at the next computer start-up:

ALERT! Cover was previously removed.

8.

Reset the chassis intrusion detector

by changing Chassis Intrusion to On or On-Silent.

NOTE:

If an admin password has been assigned by someone else, contact your network administrator for information

on resetting the chassis intrusion detector.

9. Remove the card's driver from the operating system.

10. If you removed a sound card:

a.

Enter system setup

, select Audio Controller, and change the setting to On.

b. Connect external audio devices to the audio connectors on the computer back panel.

11. If you removed an add-in network connector:

a.

Enter system setup

, select Network Controller, and change the setting to On.

b. Connect the network cable to the integrated connector on the computer back panel.

PCI Express Cards

Your computer supports one PCI Express x16 card.