Dell OptiPlex GX280 - Manual (Page 58)

Back to Contents Page
Chassis Intrusion Switch
Dell™ OptiPlex™ GX280 Systems User's Guide
Removing the Chassis Intrusion Switch
Replacing the Chassis Intrusion Switch
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in
the Product Information Guide.
Removing the Chassis Intrusion Switch
1. Follow the procedures in " Before You Begin ."
2. Disconnect the chassis intrusion switch cable from the system board.
Note the routing of the chassis intrusion cable as you remove it from the chassis. Chassis hooks may hold the cable in
place inside the chassis.
3. Using a flat blade screwdriver, gently slide the chassis intrusion switch out of its slot, and remove the switch and its
attached cable from the computer.
Small Form Factor Computer
Small Desktop Computer