beautypg.com

Connecting and disconnecting drive cables – Dell OptiPlex GX280 User Manual

Page 63

background image

When you install a drive, you connect two cables—a DC power cable and a data cable—to the back of the drive and to the

system board.

Drive Interface Connectors

IDE Drive Connector

Serial ATA Connector

1 interface connector
2 interface cable

Most interface connectors are keyed for correct insertion; that is, a notch or a missing pin on one connector matches a tab or

a filled-in hole on the other connector. Keyed connectors ensure that the pin-1 wire in the cable goes to the pin-1 end of the

connector. The pin-1 end of a connector on a board or a card is usually indicated by a silk-screened "1" printed directly on

the board or card.

Power Cable Connector

1 power cable
2 power input connector

Connecting and Disconnecting Drive Cables

When removing an IDE drive data cable, grasp the colored pull tab and pull until the connector detaches.

When connecting and disconnecting a serial ATA data cable, hold the cable by the black connector at each end.

Like IDE connectors, the serial ATA interface connectors are keyed for correct insertion; that is, a notch or a missing pin on

one connector matches a tab or a filled-in hole on the other connector.