Dell OptiPlex GX280 - Manual (Page 345)

1 power cable
2 floppy-drive cable
3 floppy-drive connector (FLOPPY)
5. Close the computer cover.
NOTICE: To connect a network cable, first plug the cable in to the network wall jack and then plug it in to the
computer.
6. Connect your computer and devices to their electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for drive operation.
7. After you open and close the cover, the chassis intrusion detector, if installed and enabled, causes the following
message to appear on the screen at the next computer start-up:
ALERT! Cover was previously removed.
8. Reset the chassis intrusion detector by changing Chassis Intrusion to On or On-Silent.
NOTE: If an admin password has been assigned by someone else, contact your network administrator for information
on resetting the chassis intrusion detector.
9. Enter system setup and use the Diskette Drive option to enable your new floppy drive.
10. Verify that your computer works correctly by running the Dell Diagnostics .
CD/DVD Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in
the Product Information Guide.