Dell C3765dnf Color Laser Printer - Manual (Page 340)

338 Copying
Margin
To specify the margins of the copy:
1 Select the Output tab.
2 Select
until Margin appears, and then select Margin.
3 Select or , or use the number pad to enter the desired value.
* Denotes the factory default settings.
Using the ID Card Copy
NOTE: If the Function Enabled setting for ID Card Copy is set to Disable , the ID card copy function is disabled and the
menu is not displayed on the screen. For details, see "Function Enabled."
You can copy both sides of an ID card on one side of a single sheet of paper in its original size by selecting ID Card
Copy on the touch panel. This feature helps to show both sides of an ID card in one page in its original size.
To make a copy:
1 Place an ID card facing down on the document glass, and close the document cover.
For details about loading a document, see "Making Copies From the Document Glass."
2 Press the (Home) button.
3 Select ID Card Copy.
4 Specify the copy settings below as required.
• Output Color
• Select Tray
• Darken / Lighten
• Auto Exposure
• Sharpness
• Color Saturation
For details, see "Setting Copy Options."
5 Press the (Start) button to begin copying.
After the front side of the ID card is scanned, the display prompts you to turn over the card.
a To scan the back side of the ID card, turn the ID card over and select Continue or press the (Start)
button.
b To finish copying, select Print Now.
NOTE: Color copy is secured with a password if the Function Enabled setting for Copy is set to On (Color
Password) . If you set Output Color to Full Color and the Function Enabled setting for Copy to On
(Color Password) , you will need to enter the four digit password after pressing the (Start) button.
Top / Bottom 0.2 inch* (4 mm*) Specify the value in increments of 0.1 inch (1 mm).
Available Range: 0.0–2.0 inches (0–50 mm)
Left / Right 0.2 inch* (4 mm*) Specify the value in increments of 0.1 inch (1 mm).
Available Range: 0–2.0 inches (0–50 mm)
Middle 0 inches* (0 mm*) Specify the value in increments of 0.1 inch (1 mm).
Available Range: 0–2.0 inches (0–50 mm)