Unitec Wash Select II With WashPay Integration Operations Manual - Manual (Page 85)

W A S H S E L E C T I I
Document Number: WS21058 73
Document Title: WSII Operations Manual ver 6.10
4.9.1 Card Reader Related System Settings
After repeated use, the credit card reader acceptance rate will begin to decline. This is due
primarily to the internal sensing devices becoming soiled. It is best to clean your card reader
using card reader cleaning cards. These cleaner cards may be purchased directly from your
distributor or from the manufacturer of the cleaner cards. The cleaner cards are Unitec stock
#MS2031 and can also be purchased from Clean Team by calling 1-800-888-8830.
4.9.2 System Settings Affecting Card Reader Operations
The following Wash Select II system settings will have an effect on how the Card Reader
operates.
Table 17. Card Reader Related System Settings
Setting Effect
Credit Mode 0 – no credit The card reader will not recognize or try to process
a transaction being made by any credit/debit cards,
but it will process fleet and pass card accounts.
Credit Mode 1 – Demo mode The card reader will log, process, and track all
cards. All credit/debit cards are immediately
“accepted” by the reader.
Credit Mode 2 – EDC mode Normally, the card reader will only accept valid
major credit cards, fleet cards, and pass cards. If
the “Accept Propriety” setting is enabled, the
reader will also accept proprietary credit/debit
cards.
Credit Mode 3 – Generic
Terminal mode Same effect on the reader as Credit Mode 2.
Credit Mode 4 – POS Auth
mode The card reader will accept any credit/debit card
swiped, as well as fleet cards and pass cards.
Credit Mode 5 – EDC Sheetz
Mode The card reader will accept any credit/debit card
swiped, as well as fleet cards and pass cards.
Credit & Coupon If this is disabled, the card reader will not accept
card swipes that occur after a coupon code/card
entry but before the purchase of a wash.
Allow Upgrades If this is enabled and the credit mode is 4, the card
reader will accept credit/debit card swipes that
follow wash purchases, as long as an upgrade is
available.
4.10 Thermal Printer Assembly
The printing operation involves the use of three different components. These components are
the main CPU, the printer control board, and the print head mechanism. These components