Unitec Wash Select II With WashPay Integration Operations Manual - Manual (Page 27)

W A S H S E L E C T I I
Document Number: WS21058 15
Document Title: WSII Operations Manual ver 6.10
Yes/Latched – Relays are turned on when the arming signal is sent to the car wash. These
relays stay on until the customer purchases an upgrade (provided upgrades are enabled) or
the wash becomes “In Use”.
No/Pulsed – Relays are turned on for a two second pulse when the arming signal is sent to
the car wash. These relays will not be re-activated unless an upgrade is purchased (provided
upgrades are enabled).
Use the steps below to assist you when enabling this feature.
1. Place the WSII in Setup mode. Scroll to: Wash Interface (*) Relay Latching (*)
2. Press the (1) key for “YES” (Latched) or the (3) key for “NO” (Pulsed).
Default Setting = No/Pulsed
2.5.3 Configure the Wash Relay Pattern
The “Wash Relay” pattern allows you to decide which relays will be turned on for each wash
package. The industry standard is that one relay should be turned on for each wash package.
The Wash Select II provides eight wash relays, which allows the relay pattern to be re-
configured if you wish to change a wash to another output relay. This is helpful if a relay were
to fail. Switching the wash to another output relay avoids having to replace parts. The wash
relays may be used in any combination for each wash.
The following steps will help you set the wash relay pattern.
1. Place the WSII in Setup mode. Scroll to: Wash Interface (*) Relay Pattern (*)
2. Enter the wash number of the relay pattern you would like to program, and then
press the (*) key to enter.
3. Turn on the relay you wish to use for this wash. This is done by using the Wash
Select II keypad to select number of the relay you would like to have on while this
wash is in service.
E X A M P L E :
If you wish to turn on relays 1, 3, and 7 the pattern should be shown as follows.
12345678 relays
1 3 7
This denotes that relays 1, 3, and 7 are turned on and the remaining relays are turned off.
Note:
Remember when setting your wash relay pattern that wash 1 is the wash in the bottom
display screen and that wash 4 is in the top display screen.
D E F A U L T :
Wash 1: Relay 1 only
Wash 2: Relay 2 only